Дословно :
DTC B1013 Seat weight sensor calibration error
DETECTION
CONDITION
Warning
• Detection conditions are for understanding the DTC outline before performing an inspection.
Performing an inspection according to only the detection conditions may cause injury due to
an operating error, or damage the system. When performing an inspection, always follow the
inspection procedure.
• Calibration set value not within valid range.
POSSIBLE
CAUSE
• Weight acting on passenger-side seat during calibration
• Improperly installed passenger-side seat part at time of calibration
• Deformed floor where attached to passenger-side seat
• Deformed passenger-side seat under-bracket or frame
• Seat weight sensor deformed or malfunction
• Seat weight sensor control module malfunction
• SAS control module malfunction
• Load to or deformation of the seat belt rail
|